Dodge Caliber Key Fob Programming From Weir 78674 TX USA

2008 Dodge Avenger
2009 Dodge Avenger
2010 Dodge Avenger
2011 Dodge Avenger
2012 Dodge Avenger
2013 Dodge Avenger
2007 Dodge Caliber
2008 Dodge Caliber
2009 Dodge Caliber
2010 Dodge Caliber
2011 Dodge Caliber
2012 Dodge Caliber
2007 Dodge Durango
2008 Dodge Durango
2009 Dodge Durango
2004 Dodge Grand Caravan
2005 Dodge Grand Caravan
2006 Dodge Grand Caravan
2007 Dodge Grand Caravan
2004 Dodge Caravan
2005 Dodge Caravan
2006 Dodge Caravan
2007 Dodge Caravan
2006 Dodge Charger
2007 Dodge Charger
2005 Dodge Magnum
2006 Dodge Magnum
2007 Dodge Magnum
2007 Dodge Nitro
2008 Dodge Nitro
2009 Dodge Nitro
2010 Dodge Nitro
2011 Dodge Nitro
2006 Dodge RAM Pickup
2007 Dodge RAM Pickup
2008 Dodge RAM Pickup

🔽 Here is a list of each step with helpful timestamps 🔽

IMPORTANT NOTES: This procedure can only be used on vehicles built in the USA. You must have two working programed remote/keys before you can add a third remote or key. If you only have one working remote/key, this procedure will not work.

00:38 – Insert the first valid key into the ignition switch.
00:44 – Turn the ignition switch to the on/run position for at least three seconds, but no longer than 15 seconds. Turn the ignition switch to the lock position and remove the first key.
00:55 – Insert the second valid key into the ignition switch.
00:59 – Turn the ignition switch to the on/run position within 15 seconds. After 10 seconds, a chime will sound. In addition, the Vehicle Security Light will begin to flash.
01:10 – Turn the ignition switch to the lock position and remove the second key.
01:15 – Insert the new key into the ignition switch.
01:19 – Turn the ignition switch to the on/run position within 60 seconds. After 10 seconds, a single chime will sound. In addition, the Vehicle Security Light will stop flashing.
01:29 – To indicate that programming is complete, the Vehicle Security Light will turn on again for a few seconds and then turn off.
01:38 – The new key is now programed. The Remote Keyless Entry remote will also be programed during this procedure. Repeat this procedure to program up to eight keys.

🛑 PLEASE NOTE –
1. At least TWO working keys that starts your vehicle are required to complete this process.
2. Most programming procedures are timed. Please verify the time limit in your manual before attempting this process.
3. The key/remote and vehicle in this example may differ from yours and are used to illustrate the pairing steps you’ll follow.

⭐Be sure to check out our website for affordable, high-quality car remotes and other Car Keys Express exclusive services!